Snap-On VERDICT M2 - M2 Data Acquisition Device Controls and Features

19
Navigation M2 Data Acquisition Device Controls and Features
z To use the camera:
1. Press the Camera button.
The camera screen opens and the button now becomes the shutter.
2. Focus the image to be captured in the view finder.
3. Press the Camera button.
The view finder now shows the captured picture.
4. Select OK to save the image, or Delete to delete it.
The view finder is live and the Camera button is the shutter, repeat steps 2, 3, and 4 to take
additional pictures.
5. Select Exit from the live view to close the camera application.
4.1.2 LEDs
There are two light-emitting diodes (LEDs) on the front face of the device:
• Power Indicator LED—this device uses three colors to show the battery and power status as
follows:
– Green indicates a either a battery with a full, or nearly full, charge or DC power
– Orange indicates a battery that is charging. An orange LED that fades on and off at three
second intervals indicates the unit is in Standby mode.
– Red indicates a low battery (15% of capacity or less).
• Hard Drive Activity LED—illuminates when the central processing unit (CPU) is reading or
writing to the hard disk drive (HDD).
4.1.3 The Stand
The built-in stand extends from the back of the unit to allow hands-free viewing. The stand clips
into the unit for storage and pivots out so the display is at a 35 degree angle when in use.
4.2 M2 Data Acquisition Device Controls and Features
There are two sets of controls for the M2 Data Acquisition Device:
• Rotary Selector Switch—establishes the primary operation of the unit
• Soft Keys—select additional functions, which vary depending upon the position of the Rotary
Selector Switch
The following sections describe the external controls and features of the M2 unit.
4.2.1 Rotary Selector Switch
Turning the Rotary Selector Switch determines the primary function of the M2 unit.