Snapper LE317 - Drive System & Controls; Causes for Repair (Drive System)

Section VIII - OVERHAUL & REPAIR (drive system)
8.1 DRIVE SYSTEM & CONTROLS
Shown below in Figure 8.1 are those components
which make up the Drive System Group. Only
those components which are worn, broken or
othenwise unserviceable should be replaced as
new parts when doing a complete overhaul of the
Drive System.
8.2 CAUSE FOR REPAIR (DRIVE SYSTEM)
Most causes for repairs to the Drive System are
as follows:
A. Drive Belt worn or broken.
B. Cable Guide and/or Belt Guide loose or broken.
C. Idler Spring is loose or broken.
D. Engine requires service.
NOTE
REPAIR INSTRUCTIONS FOR A THRU D
CAN BE FOUND ON PAGES 21 THRU 22 .
ENGINE
(SEE ENGINE OVifNER'S MANUAL
FOR SERVICE A REPAIR)
DRIVE PULLEY
CONTROL CABLE
CLUTCIVBRAKE
ARM PIVOT
BELT KEEPER
DRIVE BELT
AUGER PULLEY
IDLER ASSEMBLY
IDLER SPRING
PIVOT BUSHING
sne* HEX NUT
BELT GUARD
FIGURE 8.1
20