Snorkel A46JRT - Page 84

Appendix C – Inspection Checklists
A46JRT – 0260996
Frequent Maintenance – Every 90 Days or 150 Hours
Item Procedure Information P/F/R
Daily maintenance Perform maintenance as per schedule Retain copy of checklist
Preventive inspection
maintenance checklist
Perform inspection, complete form Retain copy of checklist
Placards and decals inspection Inspect using drawing and parts listing
in Section 1 – Repair Parts Manual
Replace any missing or
unreadable decals/placards
Door hinges and latches Lubricate SAE 10W oil or spray
lubricant
Rotation bearing Lubricate Extreme pressure grease
Above 10° F
NLGI Grade 2
Below 10° F
NLGI Grade 1
Rotation bearing teeth and
pinion
Lubricate Open gear lubricant
ASTM D 445
Gear hubs Check uid level, ll if low Gear lubricant
SAE Grade 80W-90
Platform rotator Check for proper operation Repair or replace if not
working properly
Platform controller Check smooth operation & speeds
Batteries Check specic gravity 1.260/1.275 at 80° F
Charging system Check operation
Engine RPM Check for proper engine RPM See engine owner’s manual
Engine oil and lter Replace per engine owner’s manual See engine owner’s manual
Engine fuel lter Check condition Replace every 6 months or if
dirty
Performed by: Date:
Model Number: Serial Number:
Maintenance Table Key: P = Pass, F = Fail, R = Repaired