S2646/S3246 Maintenance – 5
Performed by: Date:
Item Inspect For Ok
Operator’s Manual Proper manual in holder
Electrical System
Battery fluid level Proper level
Battery terminals Clean, connectors tight
Battery charger Proper operation
Cables and wiring harness No wear or physical damage
Hydraulic System
Fluid level Between full and add marks with platform stowed
Hoses, tubes, and fittings No leaks, all fittings tight
Free-wheeling valve Fully closed
Tires Good condition
Wheels All wheel lug nuts present and tight
Ground Strap In place and securely fastened
Lower Control Station
Operating controls Proper operation
Emergency stop Shuts off lower controls
Lowering alarm Sounds when platform lowers
Pothole Protector Interlock Proper operation
Emergency Lowering System Proper operation
Safety Prop No damage or deformation
Flashing Light Proper operation, no damage or deformation
Structures
Weldments – Scissors, chassis, steps, platform, etc. Welds intact, no damage or deformation
Slide pads In place, no damage or deformation
Fasteners In place and tight
Upper Control Station
Guardrail system Welds intact, no damage or deformation
All fasteners in place, no loose or missing parts
Platform floor No damage or deformation
Clean to prevent slip and fall hazards
Platform extension Proper operation, no damage or deformation
Swing-down rails Fasteners in place, proper operation
Lanyard anchors In place, no damage or deformation
Entry chain/gate In place, no damage or deformation, proper operation
Brakes Proper operation
Operating controls Proper operation
Emergency stop Shuts off upper controls
Lowering alarm Sounds when platform lowers
Drive motion alarm Sounds when aerial platform moves
Electrical power outlet Proper operation
Battery condition indicator Proper operation
Horn Sounds when activated
Placards and Decals In place and readable
Daily Prestart Inspection
To Next Page
