Maintenance – 10 S2646/S3246
Procedure
Verify the chassis inclination is be-
tween 4.2 and 4.4 degrees. Verify that
the lift function cuts out automatically
and the alarm sounds before the plat-
form reaches an elevation of 6 feet.
All drive functions must also cut out.
D. Repeat steps B and C elevating the
rear tires.
E. Place the smart level on the chassis
in the side-to-side direction. Zero the
level.
Elevate the tires on the right side of
the machine approximately 1 1/8 inch
Verify the chassis inclination is no
more than 1.7 degrees. Verify the plat-
form will raise and lower through its
full range of motion.
F. Elevate the tires on the right side of
the machine approximately 1 3/4 inch
Verify the chassis inclination is be-
tween 2.2 and 2.4 degrees. Verify that
the lift function cuts out automatically
and the alarm sounds before the plat-
form reaches an elevation of 6 feet.
All drive functions must also cut out.
G. Repeat steps E and F for the left side
of machine.
H. Adjust or replace the level sensor as
required.
Frequent Inspection and Maintenance – Every 90 Days or 150 Hours
Ok
Item
Level Sensor Interlock Test
Information
Performed by: Date:
To Next Page
