Page 3 - 21SL26/30SL
NOTE: During this elevation procedure, the platform will lift-stop-lift repeating the process
several times taking load readings while the work platform is in a stationary position. Do
not release the lift switch until the platform is fully elevated.
17. The suggestion “PLEASE LOWER” pops up. Use the lower control to fully lower the plat-
form. Do not release the control until the platform is fully lowered.
NOTE: During this lowering procedure, the platform will lower-stop-lower repeating the pro-
cess several times taking load readings while the work platform is in a stationary position.
Do not release the lift switch until the platform is fully lowered.
18. The question “REDO EMPTY” pops up. Press on the up arrow for yes and press “ENTER”.
19. The question “PLATFORM EMPTY” pops up. Remove the safe working load (SWL) from the
platform and press “ENTER”.
20. The suggestion “PLEASE LIFT” pops up. Use the lift controls to fully elevate the platform.
Do not release the control until the platform is fully elevated.
NOTE: During this elevation procedure, the platform will lift-stop-lift repeating the process
several times taking load readings while the work platform is in a stationary position. Do
not release the lift switch until the platform is fully elevated.
21. The suggestion “PLEASE LOWER” pops up. Use the lower control to fully lower the plat-
form. Do not release the control until the platform is fully lowered.
NOTE: During this lowering procedure, the platform will lower-stop-lower repeating the pro-
cess several times taking load readings while the work platform is in a stationary position.
Do not release the lift switch until the platform is fully lowered.
22. The suggestion “CAL DATE” pops up. Use the up and right arrows to enter the calibration
date and press “ENTER”.
23. The suggestion “FINISHED” pops up. Load calibration is now nished.
SERVICE AND REPAIR
To Next Page
Loading...
Need help?
General
