Page 3
SL26/30SL
CONTENTS
CONTENTS
INTRODUCTION 3
INSPECTION AND MAINTENANCE 4
SPECIFICATIONS 6
ILLUSTRATED PARTS
DRIVE/WORK LIGHT ASSEMBLY 8
PLATFORM ASSEMBLY WITH WORK LIGHTS 11
PLATFORM ASSEMBLY SL26 - SLIDE OUT SECTION 12
GENERATOR FABRICATION ASSEMBLY 14
GENERATOR CONTROL BOX ASSEMBLY 15
GENERATOR HOSE ASSEMBLY 16
MAIN HOSE ASSEMBLY 17
GENERATOR FITTINGS ASSEMBLY 18
POWER TO PLATFORM ASSEMBLY 19
ENGINE CABINET ASSEMBLY 20
CONTROL MODULE ASSEMBLY 22
SCHEMATIC CE(TUNNEL OPTION) 24
ENGINE SCHEMATIC & LIGHT DETAIL CE/ANSI 25
SCHEMATIC ANSI(TUNNEL OPTION) 26
HYDRAULIC HOSE SCHEMATIC 27
HYDRAULIC HOSE ASSEMBLY - FITTINGS 29
HYDRAULIC HOSE ASSEMBLY 30
HYDRAULIC HOSE ASSEMBLY 31
INTRODUCTION
This Tunnel Option Addendum manual should to be used with the current service and parts manual
issued with the machine. Some of the pages in this Addendum are intended to replace pages in the
current service and parts manual where the Tunnel Option parts have been added or changed.
Pages that are intended to be direct replacements to the current service manual have been identi-
ed with a (Rep Page *-*) next to the page number (bottom right).
The Rep Page number will correspond to a page in the current service and parts manual to be re-
placed (ie. “Rep Page 5-2”, would replace Page 5-2 in the current service and parts manual).
To Next Page
Loading...
Need help?
General
