socomec COUNTIS E23 - 1 Documentation; 2 Danger and Warning; Risk of Electrocution, Burns or Explosion; Risk of Damaging Device

3
COUNTIS E23/E24 - Ref.: 542 102 A
COUNTIS E23/E24 MODBUS
1. Documentation
All the documentation for COUNTIS E23/E24 equipment is available
online at:
www.socomec.com/en/countis-e2x
2. Danger and warning
This equipment must only be installed by professionals.
The manufacturer shall not be held responsible for failure to comply with the instructions in this manual.
2.1. Risk of electrocution, burns or explosion
• Thedevicemustbeinstalledandservicedonlybyqualiedpersonnel.
• Alwaysuseanappropriatevoltagedetectiondevicetoconrmtheabsenceofvoltage.
• Replace all devices, doors, and covers before turning on power to this equipment.
• Always supply the device with the correct rated voltage.
Failure to take these precautions could cause serious injuries.
2.2. Risk of damaging device
Check the following:
• the mains frequency (50 Hz).
• the maximum voltage at the voltage input terminals is 276 VAC phase/neutral.
• a maximum current of 63 A.
3. Preliminary operations
For personnel and product safety, please carefully read the contents of these operating instructions before installation.
Check the following points as soon as you receive package containing the COUNTIS E23/E24:
• the packaging is in good condition,
• the product has not been damaged during transportation,
• the product reference number conforms to your order,
• the packaging contains the product, two sealable covers, two plastic seals and a Quick Start guide.