- 13
To exit setting-up mode, press repeatedly until the measurement screen is restored.
3.3.1 Button Operation
1. After Entering the Setting manu, use the and buttons to select the
required item from the menu. Selection does not roll over between bottom and top of list
2.
Press
to confirm your selection.
3. If an item flashes, then it can be adjusted by the and buttons. If not,
there may be a further layer.
4.
Having selected an option from the current layer, press to confirm your selection. The
SET indicator will appear.
5.
Having completed a parameter setting, press to return to a higher menu level. The SET
indicator will be removed and you will be able to use the and buttons for
further menu selection.
6.
On completion of all set-up, press repeatedly until the measurement screen is restored.
3.3.2Number Entry Procedure
When setting up the unit, some screens require the entering of a number. In particular, on entry to the
To Next Page
Loading...
