socomec COUNTIS M33 - Stop Bit; Pule Output

- 17
-
2-1
Press to enter the selection
routine. The current setting will flash.
2-2
Use and
buttons to choose Parity (EVEN / ODD /
NONE)
3.3.7 Stop bit
Option：1 or 2.
1
From the Set-up menu, use
and buttons to select the
Stop Bit option.
2
Press to enter the selection
routine. The current setting will flash.
Use and
buttons to choose Stop Bit (2 or 1)
Note: Default is 1, and only when the parity is NONE that the stop bit can be changed to 2.
3.3.8 Pulse Output
This option allows you to configure the pulse output 1. The output can be set to provide a pulse for a