- 13
6.
On completion of all set-up, press repeatedly until the measurement screen is restored.
3.3.2Number Entry Procedure
When setting up the unit, some screens require the entering of a number. In particular, on entry to the
setting up section, a password must be entered. Digits are set individually, from left to right. The
procedure is as follows:
1.
The current digit to be set flashes and is set using the and
2. Press to confirm each digit setting. The SET indicator appears after the last digit has
been set.
3. After setting the last digit, press to exit the number setting routine. The SET indicator
will be removed.
3.3.3
Set Password
1
Use the and
to choose the change password option
2-1
Press the to enter the
change password routine. The new
password screen will appear with the
first digit flashing
To Next Page
Loading...
