socomec COUNTIS M43 - 3.3.10 Pulse Output

- 19
-
3.3.10 Pulse Output
This option allows you to configure the pulse output. The output can be set to provide a pulse for a
defined amount of energy active or reactive.
Use this section to set up the pulse output 1—Units: Total kWh, Total kVArh
1
From the Set-up menu, use and
buttons to select the Pulse output
option.
2
Press to enter the selection
routine. The unit symbol will flash.
Use and buttons to
choose kWh or kVArh.
On completion of the entry procedure, press
to confirm the setting and press
to return to the main set up menu.
3.3.11Pulse Constant
Use this to set the energy represented by each pulse. Rate can be set to 1 pulse per
0.01kWh/0.1kWh/1kWh/10kWh/100/1000kWh.