Sofar solar KTLX-G3 Series - Page 47

SOFAR 15~24KTLX-G3 User manual
Copyright © Shenzhen SOFARSOLAR Co., Ltd.
- 43 -
(A)Enter setting Interface as below：
1.Enter Setting
--------Long press DOWN button
1.Set time
2.Clear Energy
3.Clear Events
4.Country Code
5.On-Off Control
6.Set Energy
7.Set Address
8.Set Input mode
9.Set Language
10.MPPT Scan
11.Logic Interface
12.Set Power Ratio
Long press the button to Enter the main interface of "1. Enter Setting" and
long press to enter the setting menu. You can select the content you want to set by
short pressing the button.
Note1: Some settings need to enter the password (the default password is
0001), when entering the password, short press to change the number, long press
to confirm the current number, and long press after entering the correct password.
If "password error, try again" appears, you will need to re-enter the correct
password.
1. Set Time
Set the system time for the inverter.
2. Clear Energy
Clean the inverter of the total power generation.
3. Clear Events
Clean up the historical events recorded in the inverter.