BTS 5K user manual
Copyright © Shenzhen SOFARSOLAR Co., Ltd
3.2. Preparation for Installation Tools
Prepare tools for installation and electrical connections.
Table 3.2-1 Tools required for installation and electrical connections
Hammer drill
Recommend
Drill @ Φ8mm
Used to drill holes on the
wall.
Remove and install screws
and wires
Remove the output terminal
of the battery module and
BDU
Install Fixed support rack
Used to crimp OT connector
Used to coated with heat
shrinkable casing
Check whether the cable
connection is correct, the
positive and negative
terminals of the battery are
correct, and the grounding is
reliable
To Next Page
Loading...
Need help?
General
