Sofarsolar HYD 5KTL-3PH - Page 103

OPERATION OF THE DEVICE
HYD 5K...20KTL-3PH 103
sets the maximum feed-in power.
This function must be used
together with an external current
transformer or the smart meter.
Details regarding this can be found
in the “Communications interfaces”
chapter of this manual
4. IV Curve Scan
Cyclical scanning of the IV curve in
order to find the global point of the
maximum output. Advisable in the
case of shaded solar generators
Scan Control
Enable / disable IV curve scan
function
Scan Period
Set scan period in minutes
Force Scan
Manually start IV curve scanning
5. Logic interface (DRMs)
Activates or deactivates logical
interfaces. Details regarding this
can be found in the
“Communications interfaces”
chapter of this manual
6. Factory Reset
Resets stored data in the inverter
Clear energy Data
Clears total power production
Clear Events
Clears historical events
7. Parallel setting
Defines configuration for parallel
inverter operation (Master/Slave)
Parallel Control
For inverters connected with Link
port to each other, you set Parallel
Control to “Enable”