Sofarsolar SOFAR 1100TL - Page 63

OPERATION OF THE DEVICE
SOFAR 1100...3300TL-G3 63
6. Activate country setting
Activate this option before setting
the country.
Attention: If the inverter has been
supplying for more than 24 hours,
then the country setting has been
deactivated. It can only be carried
out in accordance with the LCD
setting. Enter the password for the
country setting via the LCD display
(standard: 0001)
7. Total energy
Sets the total energy.
8. Modbus address
Enter the Modbus address (when
several inverters require
simultaneous monitoring), standard:
01
9. Input mode
For the SOFAR inverter input mode,
either parallel mode or independent
mode may be selected. For devices
with an MPPT, the setting will have
no effect.
10. Set language
Sets the display language of the
inverter
11. Set start parameters
The user can change the inverter
via a USB stick. Firstly, the user
must copy any parameter
information to be changed to the
USB stick. To use this function,
please contact SOFARSOLAR’s
technical support department
12. Safety voltage
13. Set safety frequency
14. Insulation resistance