Why does the air control turn on and off by itself in my Softub Hot Tub?
The air control turning on and off by itself during heat calls and filter cycles in your Softub Hot Tub indicates that the tub is automatically adding ozone, which is a normal function.
Guidance on choosing an appropriate location for the Softub installation.
Instructions for setting up the Softub in an outdoor environment.
Guidelines for installing the Softub within an indoor space.
How to adjust and maintain the desired water temperature.
Information on operating the jets and their timer function.
Details on the automatic filtration cycle and its programming.
Explanation of the ozone system and its function as a sanitizer.
How to operate the air control valve for jet customization.
Instructions for setting and using the patented combination lock.
Essential steps for maintaining proper water chemistry and sanitation.
Cleaning and care instructions for the tub's inner liner.
Information on cleaning and maintaining the exterior vinyl material.
Procedure for removing and cleaning the spa filter.
Guidelines for properly storing and transporting the Softub.
Proper water levels required for operation and to avoid damage.
Steps for safely filling and draining the Softub spa.
Common problems and solutions for Softub operation.
Explanation of error codes and their meanings for the control panel.
General| Model | 140 |
|---|---|
| Seating Capacity | 1-2 persons |
| Water Capacity | 140 gallons |
| Jets | 5 |
| Power Consumption | 1.5 kW |
| Cover Included | Yes |
| Outer Diameter | 152 cm (60 inches) |
| Inner Diameter | 127 cm (50 inches) |
| Height | 24 inches |
| Electrical Requirements | Standard 120V outlet |
| Shell Material | Fiberglass |
| Material | PolyBond foam |
To Next Page
