Software House RM2L-NH User Manual

1
RM2L-NH-Keypad Arming Station
Quick Start
Installation Guide
Version A5
Document Part Number UM-235
July 2009
OVERVIEW
This guide provides quick start installation and connection information for the
RM2L-NH Keypad Arming Station. The device has a keypad and LCD but no read
head.
Figure 1 illustrates the RM2L-NH Keypad Arming Station.
FIGURE 1. RM2L-NH Keypad Arming Station
RM2L-NH

Software House RM2L-NH Specifications

General

Brand	Software House
Model	RM2L-NH
Category	Controller
Language	English

Summary

Overview

Specifications

Installation

Standards

Standards compliance for access control units and wiring.

Install the RM Mount Plate

Steps and diagrams for mounting the RM plate.

Wire the RM2L-NH Device Components

Wiring the Inputs, Outputs, Reader Bus

RM2L-NH SETUP

RM2L-NH Pre-wired Keypad Connections

Grounding and Shielding

Single RM2L-NH Keypad

Grounding and shielding for single keypad installations.

Multiple RM Bus Devices

Grounding and shielding for bus configurations with multiple devices.

Setting Module Address and EOL Termination

Configuring device address and EOL termination on the bus.

Wiring Inputs and Outputs

Installing the ARM-1 Relay Module

Installing the Heater (optional)

Applying Heater Strips

Installing the Thermostat

Testing RM2L-NH Keypads

Canadian Radio Emissions Requirements

FCC Digital Device Limitations