Sola Neumasem Plus - Seed Distribution Shaft Speed; Display Shaft Speed; Distribution Shaft Speed Alarm; Set Alarm Speed for Distribution Shaft

Sola Neumasem Plus Drill Control
20
7. Seed Distribution Shaft Speed
Display Shaft Speed
Select the channel.
Shaft Speed displays for 10 seconds before
returning to the tramline display.
Distribution Shaft Speed Alarm
The default alarm setting is 0 rpm. When set >0,
and the seed shaft rpm goes below the threshold or
stops, the instrument will sound 5 beeps and will
default to the channel from the current channel
selected.
The audible alarm will continue to sound every 30
seconds until the alarm condition is resolved.
NOTE: The alarm is temporarily inhibited if another
channel is selected, or if the forward speed is less
than 2 km/hr.
Set Alarm Speed for Distribution Shaft
1. Select the channel.
2. Hold to enter programme mode 1.
The alarm threshold is displayed after 5
seconds. Continue holding the button
and…
3. PRESS to select the digit to change.
Figure 17: Distribution Shaft speed