SolarEdge SE100K User Manual

CAUTION!
This unit must be operated according to the technical specification datasheet
provided with the unit.
 ATTENTION!

Cette unité doit être utilisée selon les spécifications de fonctionnement, comme
décrit dans la dernière fiche technique des spécifications.
CAUTION!
HEAVY OBJECT. To avoid muscle strain or back injury, use proper lifting
techniques, and if required - a lifting aid.
ATTENTION!
Objet lourd. Pour éviter la fatigue musculaire ou des blessures au dos, utilisez
des techniques de levage appropriées et, si nécessaire - un auxiliaire de levage
lors du retrait.
NOTE
This inverter is provided with an IMI (Isolation Monitor Interrupter) for ground
fault protection.
NOTE
The state of the ungrounded PV array may temporarily changed during
Isolation tests (resistor is connected between DC+ and DC- and GND points)
and PID rectifier operation (small resistance is connected between DC- and
GND points).
NOTE
The inverter is rated for:
• Overvoltage category: IV
• Pollution degree: 2
NOTE
The symbol
appears at grounding points on the SolarEdge equipment. This
symbol is also used in this manual.
IMPORTANT SAFETY INSTRUCTIONS / CONSIGNES DE SÉCURITÉ
IMPORTANTES
11
Three Phase Inverters with Synergy Technology PN: SExxK-xxxxIxxxx

SolarEdge SE100K Specifications

General

Max. Efficiency	98.8%
Transformer-less	Yes
Protection Rating	IP65
Frequency	50/60 Hz
AC Output Power	100 kW
Rated AC Power	100, 000 W
Maximum DC Power	135000 W
AC Voltage	400 V
Max. Input Voltage	1000Vdc
Operating Temperature Range	-25°C to 60°C