What to do if I see the 'Device limit reached' message for SolarEdge Smart Energy Accessories?
If you see the 'Device limit reached' message on the LCD when trying to add a SolarEdge Accessories device, it means you're trying to connect more than 10 devices to the load management network. To fix this, remove an unused device from the device list before adding a new one.
How to fix SolarEdge Accessories communication issues with an asterisk displayed?
If an asterisk appears next to the device type in the device manager screen, the number of detected devices doesn't match the number of communicating devices, and the green LED is off, it indicates a communication problem with your SolarEdge Accessories device. This is likely because the device isn't associated with the inverter. Here are a few things you can try: * Turn the device off and then on again and recheck communication. * Reset the device by pressing the button for more than 10 seconds and then repeat the association process. Note that reconfiguration is not required in this case. * From the Device Manager screen, select 'Remove Device' and then repeat the discovery process. Note that reconfiguration *is* required in this case.
General| Brand | SolarEdge |
|---|---|
| Model | Smart Energy Series |
| Category | Accessories |
| Language | English |
Copyright information, reproduction rights, and disclaimers regarding document accuracy and use.
Details equipment compliance with emission regulations and provides measures to mitigate radio frequency interference.
Explanation of safety symbols used in the document, including warnings, cautions, and notes for safe operation.
Details changes in version 1.2, including the addition of SetApp configuration.
Details changes in version 1.1, including terminology and product name updates.
Device operation mode where it turns on/off at user-set times, independent of PV power.
Device operation mode for maximizing self-consumption by automatically using excess PV power.
Step-by-step guide for configuring Smart Energy via the inverter's LCD interface.
Step-by-step guide for configuring Smart Energy using the SetApp mobile application.
Instructions on how to re-configure device operation modes (Manual, Auto) and schedules.
Explanation of the bi-color LED functions and their corresponding operational status indications.
To Next Page