SolarMax 4200S - 13 Disposal

48
4. Pull out the MC4 connector and fasten the protective covers of the plug-in connectors.
5. Check whether the heat sink (device base) has cooled off enough.
6. Remove the two screws left and right and remove the inverter from the mounting rail.
13 Disposal
Please dispose of the inverter at the end of its service life in compliance with the disposal
regulations currently valid where it is installed.
Please dispose of the inverter at the end of its service life in compliance with the disposal
regulations currently valid where it is installed. (address as stated in the section on “Trou-
bleshooting”).