18
4 Preparation before Installation
4 Preparation before Installation
4.1 Prerequisites
When assembling the system, avoid touching the battery terminals with any
metal object or bare hands. According to the design principles, T-BAT SYS-HV
will provide a safe and reliable energy. Improper operation and equipment
damage may cause overheating and electrolyte leakage. Therefore, the
above-mentioned safety precautions and warning information mentioned in this
part shall be strictly observed. If you have any question, please contact customer
service. The Chapter “2 Safety“ does not contain the provisions of all laws and
regulations at the place where the user located.
Before installation, make sure that the installation site meets the following
conditions:
■
The building can stand up to earthquakes;
■
The site shall be over 0.62 miles away from the sea, to avoid damage caused
by salt water and humidity;
■
The floor shall be flat;
■
No inflammable and explosive goods are placed within at least of 3 feet;
■
The ambiance shall be shady and cool, away from heat sources and direct
sunlight;
■
The temperature and humidity remain at a constant level;
■
The installation site requires less dust and dirt; and
■
There are no corrosive gases, including ammonia and acid vapor.
NOTE!
If the ambient temperature exceeds the operating range, the battery
pack will stop running to protect itself. The optimal temperature range
for running is 15°C to 30°C. In the allowable range, the relative humidity
range should be between 5% and 95% RH. Frequent exposure to harsh
temperatures may deteriorate the performance and lifetime of the
battery.
To Next Page
Loading...
Need help?
General
