19
4 Preparation before Installation
4.2 Safety Gear
Installation and maintenance personnel must operate according to applicable
federal, state, and local regulations as well as industry standards regarding
product installation. Personnel must wear safety gear as indicated below in order
to avoid short circuit and personal injury.
Anti-dust mask Safety boots Safety gloves Safety goggles
4.3 Installation Tools
To install the T-BAT SYS-HV system, the following installation tools are required
to be prepared.
Hammer drill Measuring tape Maker Cross screwdriver
Torque wrench (M4) Rubber mallet Spirit level Hot-air blower
Wire stripper
Crimping tool for
RJ45
φ
6mm Heat shrink
tubing
To Next Page
Loading...