34
6 Wiring
Right side of BMS (BMS to inverter)
Power cable (black): Connect BAT- of BMS to BAT- of inverter
Power cable (red): Connect BAT+ of BMS to BAT+ of inverter
Communication cable: Connect BMS port of BMS to BMS port of inverter
Power cable (red)
Communication
cable
Rotation
wrench
Lock
button
Power cable
(black)
Grounding
cable
This type of terminal is available
on both power cable
*Note:
■
Press and hold the lock button while unplugging the power cable, or it cannot
be pulled out.
■
Use the rotation wrench to tighten the communication cable, and remove it
after tightening.
To Next Page
Loading...