SolaX Power X3-Hybrid Series

To Next Page

To Previous Page

Communication connection of Parallel box side.

Step 1.Made communication lines .

Select the correct wire (cable size: see figure below).

Remove 10mm insulation from wire ends.

Plug in the communication terminal.

Step 2.Place the corresponding EPS/GND line on the two feet of the green

terminalUse a screwdriver to lock the wire.

Step 3.Fasten through the communication terminal and the corresponding

CAN port.

Step1

Step2

Step4

10.0mm

conductor

communication cable

8pin terminal

(in accessories package)

Step3

GND(pin2)EPS(pin1)

Communication interface with the X3-EPS Parallel Box for EPS and GND, two wires.

GND

1 2

EPS

Step 1 、

24AWG

green terminal

Crimp!

EPS wrie

GND wrie

Step 2

Step 3

GND wire

EPS wire

SolaX Power X3-Hybrid Series - Page 12