2.2 Important Safety Instructions
Danger!
Danger to life due to high voltages in the inverter!
All work must be carried out by qualified electrician.
The appliance is not to be used by children or persons with
reduced physical sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given
supervision or instruction.
Children should be supervised to ensure that they do not play
with the appliance.
Caution!
Danger of burn injuries due to hot enclosure parts!
During operation, the upper lid of the enclosure and the
enclosure body may become hot.
Do not touch the metallic part of the product during operation.
Caution!
Possible damage to health as a result of the effects of radiation!
Do not stay closer than 20 cm to the inverter for a long time.
Note!
Grounding the PV generator.
Comply with the local requirements for grounding the PV
modules and the PV generator. It is recommended to connect
the generator frame and other electrically conductive surfaces
in a manner which ensures continuous conduction and ground
these in order to have optimal protection of system and persons.
Warning!
Ensure input DC voltage ≤Max. DC voltage. Over voltage
may cause permanent damage to the inverter or other
losses, which will not be included in warranty!
Warning!
Authorized service personnel must disconnect both AC and
DC power from the inverter before attempting any
maintenance or cleaning or working on any circuits connected
to the inverter.
Prior to the application, please read this section carefully to ensure correct
and safe application. Please keep the user manual properly.
Use only attachments recommended. Otherwise may result in a risk of fire,
electric shock, or injury to person.
Make sure that existing wiring is in good condition and that wire is not
undersized.
Do not disassemble any parts of the inverter which are not mentioned in
installation guide. It contains no user-serviceable parts. See Warranty for
instructions on obtaining service. Attempting to maintain the inverter by
yourself may result in a risk of electric shock or fire and will void your
warranty.
Keep away from flammable, explosive materials to avoid fire disaster.
The installation place should be away from humid or corrosive substance.
Authorized service personnel must use insulated tools when installing or
working with this equipment.
PV modules shall have an IEC 61730 class A rating.
Never touch either the positive or negative pole of PV connecting device.
Strictly prohibit touching both of them at the same time.
The unit contains capacitors that remain charged to a potentially lethal
voltage after the MAINS and PV supply has been disconnected.
Hazardous voltage will present for up to 5 minutes after disconnection from
power supply.
CAUTION - RISK of electric shock from energy stored in capacitor. Never
operate on the solar inverter couplers, the MAINS cables, PV cables or the
PV generator when power is applied. After switching off the PV and Mains,
always wait for 5 minutes to let the intermediate circuit capacitors
discharge before you unplug DC and MAINS couplers.
When accessing the internal circuit of solar inverter, it is very important to
wait 5 minutes before operating the power circuit or demounting the
electrolyte capacitors inside the device. Do not open the device before
hand since the capacitors time to sufficiently discharge! require
Measure the voltage between terminals UDC+ and UDC- with a multi-
meter (impedance at least 1Mohm) to ensure that the device is discharged
before beginning work (35 VDC) inside the device.
Safety Safety
Do not operate the inverter when the device is running.
Risk of electric shock!
Warning!
Warning!
06 07
To Next Page
Loading...
Need help?
General
