59
Electrical Connection
COM 1
terminal on
the inverter
Click!
Figure 8-36 Inserting the connector to COM 1
Step 6: Secure the assembled connector on COM 1 terminal.
a. Install the connector enclosure back into the COM 1 terminal.
b. Install the cable support sleeve into the enclosure.
c. Tighten M3 screw to secure it. (Torque: 0.4 ± 0.1 N·m)
d. Clockwise tighten the swivel nut to finish the COM 1 wiring connection.
3
M3
0.4 ± 0.1 N·m
2
4
1
Figure 8-37 Securing the connector
To Next Page
Loading...
