F
F
F
F
F
Stop the engine and wait for it to cool before
refueling. Check the engine oil level and add oil if
required.
Perform all maintenance procedures outlined in
the maintenance and adjustment section of this
manual.
Check that the PTO drive locking devices are
latched.
Check that the tractor PTO shield and driveline
guards are in place and operating properly.
Check the tractor and implement hydraulic
system. Have any leaks or damaged parts
repaired or renewed.
WARNING: Diesel fuel or hydraulic fluid under
pressure can penetrate the skin or eyes and
cause serious personal injury, blindness or
death. Fluid leaks, under pressure, may not be
visible. Use a piece of cardboard or wood to
find leaks. Never use your bare hand. Wear
safety goggles for eye protection. If any fluid is
injected into the skin, it MUST be surgically
removed within a few hours by a doctor familiar
with this type of injury
Before applying pressure to the fuel or
hydraulic system, be sure all connections are
tight and that lines, pipes, and hoses are not
damaged. Before disconnecting fuel or
hydraulic lines, be sure to relieve all pressure.
Make sure that all hydraulic lines are correctly
installed and not tangled.
WARNING : Liquid cooling systems build up
pressure as the engine gets hot. Before
removing the radiator cap, stop the engine and
let the system cool.
Check the engine cooling system and add
coolant as required.
J. Clean the tractor:
Keep work surfaces and engine compartments
clean.
Before cleaning the machine, always lower
implements to the ground, place transmission in
neutral, engage the parking brake, shut off the
engine and remove the key.
Clean steps, pedals and floor. Remove grease or
oil, Brush away dust or mud. In winter, scrape
away snow and ice. Remember-slippery surfaces
are dangerous.
When plastic parts need to be cleaned (such as
console, instrument panel, monitors, indicators
etc.), do not use petrol, paraffin, diluents etc.
They could cause discoloration, cracking or
warping of the cleaned parts.
These parts should ONLY be cleaned with water,
neutral soap and a soft cloth..
Remove and store implements, keys, hitches etc.
in their proper places.
F
F
F
F
F
F
F
19
Operator Manual
To Next Page
Loading...
