VII. HYDRAULIC LEVERS
a. POSITION CONTROL LEVER (A)
It is Black Colour handle located towards the driver side which enables raising or
lowering the implement / lift. It is used when implement operation demands stable /
fixed position e.g. carrying goods in a bucket attached on three point linkage.
b. DRAFT CONTROL LEVER (B)
It is Red Colour handle locate towards right fender side which is used to control the
draft of soil on implement. By controlling the draft, the implement and tractor can be
prevented from overloading.
c. EXTERNAL HYDRAULIC CONTROL LEVER (C & D)
Used to control the oil flow into the auxiliary hydraulic circuit, either single acting or
double acting.
VII. DIRECTION CONTROL VALVES (DCV)
The DCV equipped is operated by two lever. Lever "C" is controlling Double Acting
(DA) DCV and Lever "D" is controlling convertible Double Acting (DA) Single Acting
(SA) DCV. We can convert the Convertible DCV into Double Acting (DA) by
tightening the converting screw and vice-versa for SA.
SA - Single Acting
DA - Double Acting
4.2 FOOT CONTROLS
I. CLUTCH PEDAL
By depressing clutch pedal (C) the motion and power of engine will be disengage from
gearbox. Releases the clutch pedal slowly for transfer the engine power to gearbox.
A
C
D
DA / SA QRC
DA QRC
Converting Screw
B
C
54
Operator Manual
To Next Page
Loading...
