a. METHOD TO CHECK CLUTCH PEDAL FREE PLAY
Press down the clutch pedal and measure the distance between the footrest and pad.
The distance should be 25 to 35 mm. If the distance is less than 25mm or higher than
35mm then get it adjusted. The adjustment can be down by the clutch pedal tie rod as it
is having adjustable nut.
II. DIFFERENTIAL LOCK
The differential lock mechanically locks the rear axle shaft together so that both wheels
are coupled together so that both wheels are coupled together. This is an important aid
when operating in muddy conditions as it provides increased traction, reduces wheel
slip and prevent tyre wear.
If a rear wheel starts to slip - Engage the Differential Lock.
To Engage the Differential Lock
1 Fully depress the clutch pedal.
2 Push down the differential lock pedal with your heel and this engages the
differential lock pedal
3 Release the clutch pedal slowly, while maintaining foot pressure on the differential
lock pedal
To Disengage the differential lock, release the pedal. If the lock fails to disengage
steer slightly to either left or right.
DD
Do not apply differential lock while tractor speed is more than 6 kmph on turning
Do not attempt to sheer the tractor with the differential lock in the engaged position.
CAUTION
Do not keep foot on clutch pedal while tractor is in running condition. It may cause excessive wear of clutch and clutch fails before
its lifetime.
WARNING
Adjusting Nut
55
Operator Manual
To Next Page
Loading...
