The tractor is equipped with front live axle (Optional) for better traction and pulling
where even required. The live 4WD axle is having a limited slip differential with final
epicyclic hub reduction for durability. The 4WD engagement can be done by
mechanical actuation of lever located on the lift side of operator seat. Ensure proper oil
levels in differential & hubs during routine maintenance check as also specified in
service intervals.
a. FILLING & REPLACING FRONT AXLE OIL
Align the hubs in horizontal position as marked on the hub (A) for filling & replacing
front axle oil.
7.2 SWINGINING DRAW BAR
The tractor is equipped with swingining drawbar as conforming to ECE standard. Use
correct position of bar i.e. it can be adjusted either telescopic way or can be tilted left on
right. Remove the locking pins(1) to adjust the same.
7.3 Roll Over Protection
The objective of the frame is to protect the operator in the event of a roll over and they
are designed to support the entire weight of the tractor in that event.
ROP frame is designed and has been tested to meet industry and or Government
standards including ECE Norms.
Included in these tests were all mounting bases and bolts or other fasteners.
The ROPS frame has a fold down feature, which can be used to enter low buildings etc.
Take care when lowering the upper section of the ROPS frame and take extreme care
while driving the tractor with the ROPS frame lowered.
Each ROPS has a separate serial no. Punch on the data plate which is affixed on the
ropsframe as per ECE Norms.
7. FRONT AXLE 4WD (OPTIONAL)
Do not operate 4WD axle high speeds.
WARNING
CAUTION
For trail type implements alway use the swingining bar to hitch them.
1
7.1 FRONT AXLE 4WD
A
68
Operator Manual
To Next Page
Loading...
