4. CONTROLS
4. CONTROLS
4.1 HAND CONTROLS
I. GEAR SHIFTER LEVERS
a. MAIN GEAR SHIFTER LEVER
In transmission 8-forward and 2- reverse gears are available. Main gear lever (A)
allows changing gear while tractor is moving. Release accelerator pedal and
declutch. Select required gear, release the clutch progressively and accelerate the
engine. Before changing the tractor movement from forward to reverse or reverse to
forward direction wait for the tractor to stop.
b. HIGH-LOW LEVER
This lever (B) is used to change the low speed into high speed or vice versa when
tractor is moving. According to requirement you can use it with combination with main
gear lever. Move the lever forward for high gear & vice verse for low gear speed.
II. PARKING BRAKE
Parking brake lever is mounted at left hand side of the driver (as per different models).
By pulling it upwards, you can apply parking brake to your tractor. It is used while your
tractor is in parking condition.
III. HAND THROTTLE LEVER
Hand throttle lever mounted on dashboard (Panel) is used in field application. To
increase the speed of engine, pull down the lever and to decrease pull up the lever.
IV. 4WD ENGAGE & DISENGAGE LEVER
Shift 4WD engage & disengage lever backward for 2 Wheel Drive (2WD) option &
forward for 4 Wheel Drive (4WD) Option.
V. POWER TAKE OFF
Power take off is mounted at rear side of tractor. This is used for supplying rotary power
directly to implement from engine. Power take off shaft has standard 06 Spline on
540rpm. PTO can be engaged or disengaged by PTO shifter lever.
Before driving tractor, parking brake should be released.
NOTE : When traveling downhill always remain in gear. Never declutch. The gear selected
should be same as would be used to Climb. For engaging / disengaging gear
always depress the clutch. Always use low gear while moving down slope.
To Next Page
Loading...
