a. POWERTAKE OFF SHIFTER LEVER
There are two positions for PTO lever. One Position is Neutral and Other position is
Live PTO. When PTO lever is engaged in backward direction it is called Live or Direct
PTO.
In Live or Direct PTO the speed directly depend on engine speed.
For engaging PTO set the engine to idle speed, declutch the engine and pull the lever
to backward for direct PTO
540 RPM Obtained at 1600 Engine RPM
b.. OPERATION WITH PTO
To mount PTO driven implements following steps are followed.
a. Be sure that both gear shifter levers are in neutral position and PTO lever is also in
neutral position.
b. Stop the engine, hitch or mount the implement on three-point linkage.
c. Remove PTO shaft cap and keep it to toolbox. Join the implement with PTO shaft
directly or with the help of carden shaft as per provision of implement. Follow the
instruction of implement manufacturer
VI. DRIVER SEAT
Driver seat can be adjusted according to your conveyance in following ways.
a. TRAVEL ADJUSTMENT
l By Pulling up the lever A (Located under the driver Seat) the driver Seat can be slided
and adjusted according to requirement.
By unscrewing the two knobs (R) and loosening the bolt (C) the crive seat can be
moved up and down.
b. SUSPENSION WEIGHT ADJUSTMENT
The Seat can be adjusted for better suspension according to driver weight. This can be
done by knob as shown. If you want hard suspension turn the knob (1) clockwise and if
you want soft suspension turn it to anti clockwise. When the indicator (2) indicates the
weight (approx. your weight) then the adjustment of suspension setting is at best
position.
NOTE: When the PTO is not being used put the PTO in neutral.
AA
[Do not wear loose clothes while operating PTO driven implement. If engine is in running condition do not go near the
implement. For repairing or cleaning stop the engine and wait till the implement stop rotating. Do not pass between tractors
and implement.
[Start the engine, depress the clutch, engage PTO as per requirement (operation) direct . Accelerate the engine at desired
speed and then release clutch pedal slowly.
[While using PTO operated implement in stationary condition, apply parking brake, neutral both the gearshift lever and lock all
the four wheel.
CAUTION
53
Operator Manual
To Next Page
Loading...
