SOLIS 50 - General Maintenance

5.3.5 LOWER LINKS (E)
Lower Links are provided for hitching the implement.
5.3.6 STAY BARS (F)
Stay Bars controls the swing of implement during transport and field operations. Stay
Bar are provided between side of lower link and differential housing.
5.3.7 SWINGING DRAWBAR (G)
Swinging Drawbar fitted on rear side of the differential housing is used for trailer towing
the haulage operation.
5.3.8 ATTACHING IMPLEMENT TO 3 POINT LINKAGE
Position the tractor to align corresponding linkage with the hitch points of implements.
Keep the implement on hard & leveled surface and attach as per given below
instructions
First attach with Left Lift Rod (A)
Attach with Right Lift Rod (B)
Then at Last attach with Top Link (C)
5.4 GENERAL MAINTENANCE
5.4.1 TRANSMISSION/HYDRAULIC OIL LEVEL
Keep oil level up to maximum oil level mark.
5.4.2 HYDRAULIC OIL FILTER
Hydraulic oil filter is fitted at right hand side of tractor. Remove the old filter and change
with new one dully filled with clean oil. Apply small amount of oil on rubber seal of filter
and fit it. Do not over tight the filter.
5.4.3 CHECK TRANSMISSION OIL BREATHER
The breather is located on top of the rear cover, beneath the driver seat.
Remove the breather by unscrewing it. Clean it with diesel and check it for proper
working and fit it again.
NOTE: Use proper genuine transmission oil.
EE
FF
GG
CC
AA
BB
Oil Breather
59
Operator Manual