A. TEMPERATURE GAUGE:
This gauge indicates temperature of engine coolant. GREEN zone indicates normal
temperature and RED Zone indicates engine overheating. If the needle moves beyond
normal range, towards RED zone, follow the procedure:
I Drive safely to the side of road and stop your tractor.
II Allow the engine to run idle.
III If the temperature does not go down, shut it off and allow sufficient time for it to cool.
IV Visually inspect the fan belt for looseness, breakage and all water hose connections
for leak.
V If the fan belt is OK and no coolant leak is noticed, check the coolant level.
VI Add coolant if required.
Do not remove the radiator cap when the engine and radiator are hot. Boiling
hot coolant and steam may blow out under pressure, which could cause
serious injury.The cap should only be taken off when the coolant temperature
has lowered. Necessary precaution to be taken while opening the radiator cap.
B. OIL PRESSURE GAUGE
This gauge indicates pressure of lubricating oil in the engine. If the needle enters in RED
zone, stop the engine and follow the procedure
I Stop your tractor to the side of road on leveled surface
II Wait for minimum 10 minutes after stopping the engine.
III Pull out the dipstick, wipe oil off with a clean cloth, insert & tighten the dipstick all the
way into engine, and then remove it again. The oil on dipstick should be between the
UPPER and LOWER limits.
iV If the oil level is below the lower limit, then top up with oil.
V Start the engine, allow it to run idle and don't race it immediately.
Do not operate the engine if there is no oil pressure indication.
WARNING
Green
Red
Green
Red
CAUTION
L - FOUR WHEEL DRIVE INDICATOR
F - TRAILOR INDICATOR 1
H - CLOGGING INDICATOR
E - BATTERY INDICATOR
D - FUEL GAUGE
B - OIL PRESSURE GAUGE
N - LEFT SIDE INDICATOR
C - RPM-CUM-HOUR-METER
O - RIGHT SIDE INDICATOR
A - TEMPERATURE GAUGE
J - VOLT METER
K HIGH BEAM
M - TRAILOR INDICATOR
-
I - HAZARD SWITCH
Q - HORN SWITCH
P - PARKING / HEAD LAMP SWITCH
R - SIDE INDICATOR SWITCH
1. INSTRUMENT PANEL, ELECTRICAL CONTROLS AND SHEET METAL
36
Operator Manual
To Next Page
Loading...
