VI. Water Separator Bowl
1. The water separator is used to obtain the better
functioning of fuel system
2. Drain water and contaminants from clear water
separator sediment bowl by opening drain screw (C).
A-Water Separator
B-Indicator Ring
C-Drain Screw
CAUTION
Drain the water from drain screw, if the indicator ring floats up to the level as marked on the water separator (A).
A
B
VII. CLEANING OF FUEL FEED PUMP STRAINER
Shut off fuel cock for cleaning the strainer remove it from bowl by
loosening the screw provided at bottom. Clean the element of strainer
and fit it again. Be sure that part of strainer bowl is fitted properly. Any
minor leakage in this may cause air trapping in fuel system.
VIII. CHANGING OF ENGINE OIL
Park the tractor on leveled surface. Warm up the engine up to operating
temperature and shut down, drain the oil by removing the plug. Fit drain
plug (A) and fill the clean oil through filter cap (B). Start the engine for a
while. Wait for a while, check the dipstick oil level. Always keep oil level
between maximum and minimum oil level.
At the time of oil pouring always avoid overflow condition from filter cap to
do so use proper size of funnel..
Do not fill oil over the maximum oil level mark. It may cause excessive oil
consumption.
3.7 AIR CLEANER
I. GUIDELINES FOR DRY AIR CLEANER
Clean the primary element after every 300 hrs of operation or when ever
choke indicator glows on dashboard.
Replace primary element after 3 cleaning or 900 hrs (whichever earlier).
Secondary element to be replaced after every three replacement of
primary filter.
Use clean cloth to wipe sealing areas of primary filter.
Ensure proper seating of filter into housing before latching the cover. Do
not use latches on the cover to force the filter into air cleaner that could
cause damage to housing and will void the warranty.
Strainer Bowl
C
B
A
48
Operator Manual
To Next Page
Loading...
