II. Replace Air Cleaner Elements
A—Clips
B—Cover
C—Primary Element
D—Secondary Element
E Unloader Valve —
1. Open the bonnet hood. Refer page No.20 for procedure to open the hood
2. Release clips (A).
3. Remove cover (B).
4. Remove primary element (C).
5. Clean out any dirt in canister taking care not to
damage the secondary filter element.
IMPORTANT: Remove secondary element (inner
element) ONLY if it is to be replaced.
DO NOT attempt to clean secondary
element.
If secondary element is replaced, install
new element immediately to prevent
dust from entering air intake system.
6. Removal of the secondary element (D) is similar to
removal of the primary element.
NOTE: When installing the air cleaner canister, make
sure that the dust unloader valve (E) is facing down.
7. Install secondary element, primary element and cover.
B
A
E
C
D
III. Cleaning Primary Element
1. Pat sides of element gently to loosen dirt. DO NOT tap
element against a hard surface.
2. clean element with compressed air (below 690 kPa or
100 psi). Hold nozzle next to inner surface, and move
up and down pleats.
IMPORTANT: DO NOT direct air against outside of
element, as it might force dirt through
to inside.
3. Inspect element before reinstalling.
49
Operator Manual
To Next Page
Loading...
