22
Operator Manual
WARNING: Do not start the tractor without
ensuring a perfect command of speed and
steering controls
O. Follow recommended starting
procedures
Follow the starting procedures recommended in the
operation section of this Operator instruction Book. This
includes normal starting, cold starting and use of starting
fluids.
Test the controls
After starting, recheck all gauges and lights. Make sure
everything is functioning correctly. If the tractor does not
respond correctly which each control is operated, DO
NOT use the machine until the fault is rectified
Ensure that the starter solenoid cover is always in
position.
Starting fluid
WARNING : It is very important that you read the
label on the can before using starting fluid. DO NOT
use aerosol can of starting aid on tractors with the
thermostat connected to the electrical system.
Ether combined with thermostat can cause an
explosion with damage to engine, personal injury or
both.
Handle starting fluid correctly. Starting fluid must only be
used when an ether start aid is fitted as original
equipment by the manufacturer or when installed by a
Dealer as an accessory, in case of tractors being fitted
with glow plugs or thermostat ,this must be removed
prior to the installation.
If aerosol cans of starting fluid are to be used the
thermostat must be disconnected. Remove the wire from
the thermostat unit which will be found on the induction
manifold. Tape the end of wire to prevent an electrical
short circuit.
Before starting the tractor, ensure that no persons or
hindrances are present in its range.
P. SAFETY: WORK SAFETY
WARNING : An unbalanced tractor could overturn and
cause injury or death. Make sure front
frame
counterweights, wheel weights and wheel ballast are
used as recommended by the manufacturer. NEVER
add extra counter weights to compensate for an
overload, better to reduce the load.
WARNING : Keep all parts of your body inside the
operator's compartment while operating the tractor.
Q. Make the right moves
Make sure your tractor is ready for the job it must do. Know
the rated load capacities of your tractor and never exceed
them. Be certain that any equipment or implements you
intend to use DO NOT exceed the load rating of your
tractor. Be sure the tractor and implement PTO rev/min match.
Keep in mind that tractors normally operate on uneven,
unpaved, and often bumpy or sloping surfaces. Operating
conditions can reduce the amount of weight you should carry or
pull.
To Next Page
Loading...
