4. Installation4. Installation
.15..14.
7±0.5mm
Please complete the assembling of the DC cable according to below procedures:
Step 1: Choose a proper DC cable and strip about 7+/-0.5mm, refer to the following table
for specifications.
4.0~6.0
4.0(12AWG)
(12~10AWG)
Cable type
Cross section(mm²)
Range
Industry generic P V cable
（model:PV1-F）
Recommended value
Figure 4.6 Strip
Step 5: Insert the crimped DC cable firmly into the DC terminal, then insert the waterproof
rubber ring into the DC terminal and tighten the nut.
After hearing the "click" sound, gently pull to check whether the engagement is firm.
Criew
Figure 4.10 Assemble the cover of the terminal connector
Step 2: take out the DC connector from the accessory bag, rotate the nut to remove it and
take out the waterproof rubber ring.
Positive
Negative
Nut
Waterproof rubber ring
Figure 4.7 Remove the cover of the terminal connector
Step 3: Pass the stripped DC cable through the nut and waterproof rubber ring.
Figure 4.8 Pass the cable trough
Positive
Negative
Positioning part
crimpDON'T
Step 4: Connect the conductor part of the DC cable to the metal DC terminal and press it
with the DC terminal crimping tool.
Crimp
CAUTION!
Figure 4.9 Crimp
Positive
Negative
Positive
Negative
Click
To Next Page
Loading...
