6. Operation
6.5.17 Power Parameter
This function is used for calibrate inverter output energy. It will not impact the energy count
for inverter with RGM.
The screen shows:
Press the Down key to move the cursor.
Press the Up key to change the digit.
Please press the Enter to save the setting and press the ESC key to return
to the previous menu.
Figure 6.42 Power Rate Limit
YES=<ENT> NO=<ESC>
Power para:1.000
This setting is used for grid operator, don't change setting under this manual.
6.5.14 Restart HMI
The function is used for restart the HMI.
This function is applicable by maintenance personnel only, wrong operation
will prevent the inverter from reaching maximum power.
6.5.15 Debug Parameter
This function is used for manufacturer maintenance personnel only.
6.5.16 DSP Update
The function is used for update the DSP.
This function is applicable by maintenance personnel only, wrong operation
will prevent the inverter from reaching maximum power.
7. Maintenance
Solis Single Phase Inverter does not require any regular maintenance.
However, cleaning the dust on heat-sink will help the inverter to dissipate the heat and
increase its life time. The dust can be removed with a soft brush.
CAUTION:
Do not touch the inverter's surface when it is operating. Some parts of the
inverter may be hot and cause burns. Turn off the inverter (refer to Section
5.2) and wait for a cool-down period before any maintenance or cleaning
operation.
The LCD and the LED status indicator lights can be cleaned with a damp cloth if they are too
dirty to be read.
NOTE:
Never use any solvents, abrasives or corrosive materials to clean the inverter.
.48. .49.
To Next Page
Loading...
