UM0027_ SOL APOLLO Series 7.4-22K_EN_V02_0523 31
5.3 Selecting the mounting location
1. Mount the product vertically or tilted backward by a maximum of 15°.
2. Never mount the product tilted forward or sideways.
3. Never mount the product horizontally.
4. Mount the product at eye level to make it easy to operate and to read the
LED strip.
5. The electrical connection area must point downwards.
5.4 Mounting the product
Removing the decorative cover
1. Remove the bottom screw (A) on the flat workbench.
2. It is recommended to start at the bottom of enclosure (C) when removing
the decorative cover (B).
Danger to life due to fire or explosion
• Despite careful construction, if installed incorrectly or mounted in
unsuitable locations, electrical devices can cause fires which may
result in death or serious injury.
• Do not mount the product on flammable construction materials.
• Do not mount the product in areas where flammable materials are
stored.
• Do not mount the product in areas where there is a risk of explosion.
To Next Page
Loading...