18
65EP-T/EP+-T
WARNING !!!
• Make sure that +5V DCV and +3.3 DCV of your power supply are suitable
for the processor.
• Any attempt to operate the Celeron or PIII processor without a suitable
cooling Fan will damage processor and other component.
2-1 CPU Installation
2-1.1 CPU Frequency
• The CPU’s “CPU CLOCK RATIO” and “CPU HOST/PCI CLOCK” settings
are automatically detected to be default value by BIOS in the “Frequency/
Voltage Control” section.
• We do not suggest and assume the responsibility for any action such as
overclocking that changes the CPU default setting. Incorrect CLOCK
RATIO and HOST/PCI CLOCK settings may cause damage to your CPU.
Make sure that the CPU is
placed into the socket tightly.
Then lower down the lever to
complete the CPU installation.
S
O
C
K
E
T
3
7
0
3
Take notice of the red circles
as shown here. While inserting
the CPU into the socket, you
can find out there is a definite
pin orientation for CPU and
socket.
2
Pull out the lever from the socket,
and then raise the lever up to a
90-degree angle.
SOCKET 370
1
To Next Page
Loading...
