BIOS Setup
49
Step 4. Type awdflash *.bin /sn/py/cc and then press <Enter> to run
BIOS upgrade program. (*.bin depends on your mainboard model
and version code. Instead of typing “*”, you should type specific file
name for your specific mainboard).
Step 5. Please press <F1> or <F10> to exit or reset your system, Warning !
If the message “Write Fail” appears while Award “FLASH MEMORY
WRITER” is verifying Flash memory, just repeat the process. Please
DO NOT reset or turn off the system. If the award memory flash utility
is not able to update the BIOS successfully, your system may not be
able to boot up.
Step 6. You will need a message “CMOS checksum error-Default loaded”
during booting the system. Press <Del> to run CMOS setup utility,
then reload “LOAD SETUP DEFAULTS” or “Load Optimized
Defaults” and save this change.
To Next Page
Loading...
