BIOS Setup
79
Reset Configuration
Data
Normally, you leave this Disabled. Select Enabled
to reset Extended System Configuration Data
(ESCD), when you exit Setup if you have installed
a new add-on and the system reconfiguration has
caused such a serious conflict that the operating
system cannot boot.
Resource Controlled
By
The Plug and Play AwardBIOS can automatically
configure all the boot and Plug and Play-compatible
devices. If you select Auto, all the interrupt request
(IRQ) and DMA assignment fields disappear, as the
BIOS automatically assigns them.
NOTE: BIOS will automatically disable all PnP resources except the boot
device card when you select Yes on Non-PnP operating system.
PNP OS Installed Select Yes if the system operating environment is
Plug-and-Play aware (e.g., Windows95).
IRQ-3 assigned to PCI Device
IRQ-4 assigned to PCI Device
IRQ-5 assigned to PCI Device
IRQ-7 assigned to PCI Device
IRQ-9 assigned to PCI Device
IRQ-10 assigned to PCI Device
IRQ-11 assigned to PCI Device
IRQ-12 assigned to PCI Device
IRQ-14 assigned to PCI Device
IRQ-15 assigned to PCI Device
Item Help
Menu Level
: Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
CMOS Setup Utility - Copyright (C) 1984 - 2001 Award Software
IRQ Resources
IRQ RESOURCES Press Enter at this item to reveal the following list:
To Next Page
Loading...
