6 Tips on safety
The User Manual must always be available where the device is installed.
The User Manual must be read and used by each person who works on or with the fitting punch.
6.1 Warning tips and symbols
This User Manual contains notes on possible hazards, which could arise with improper use of the
fitting punch. These notes are flagged with a keyword (Warning or Attention) and a pictogram.
It is differentiated between the following hazard symbols:
This symbol means that severe harm / damage could occur
to people or materials in case of misuse.
6.2 Intended Application
The fitting punch UNI – POWER is used for trimming the shielding bars and connecting rods in
a single operation of Maco window metal fittings, and may be used exclusively for this
application.
The device is manufactured using state-of-the-art technology and the accepted rules of safety.
Nonetheless, there could be hazards for people and material in case of misuse of the device, both for
the operator or a third party and / or damage to the device or other materials.
The device may only be used when it is in a proper condition and also for the intended application,
with an awareness of the safety and hazards associated with its use as given in the User Manual. In
particular, faults, which could affect the safe operation of the device, must be immediately rectified.
By intended application is meant, amongst others, following the instructions given in the User Manual
and complying with the inspection and maintenance requirements.
6.3 Obligations of the operator
The fitting punch UNI - Power has been designed and manufactured taking the hazard analysis into
account, and after careful selection of the harmonized standards, as well as other technical
specifications, to be complied with. It thus corresponds to the state-of-the-art technology, and
guarantees the highest possible degree of safety.
To Next Page
Loading...