74
© 2011 Somfy SAS. All rights reserved. 06/2011
EN
7.1.3. Programming the “my” position
In the “my” position, press and hold the “my” button for 5
seconds: the E.V.B. moves briey and the "my" position
has been programmed.
7.1.4. Deleting the favourite (my) position
• Press the Down button (the E.V.B. moves to the lowered
position with the slats closed).
• Press and hold the "my" and Up buttons for 2 seconds: the
slats will tilt to the programmed “My” position.
• Press and hold the "my" and Up buttons for 5 seconds: the
E.V.B. moves briey; the "my" position is deleted (the "my"
button now works only as a "STOP" button. If using a sun
sensor, the E.V.B. moves to the lowered position when the
sun appears).
7. ADDITIONAL SETTINGS
7.1. Favourite position (my)
7.1.1. Modifying/Activating the favourite (my) position
• Press the Down button (the E.V.B. moves to the lowered
position with the slats closed).
• Press and hold the "my" and Up buttons for 2 seconds (the
slats tilt to the pre-programmed "my" position).
• Position the slats as required, using the thumbwheel of
the RTS remote control to increase or decrease the slat
angle.
Go to the section entitled "Testing the my position" or
"Programming the my position".
7.1.2. Testing the “my” position (optional step)
• Briey press the "my" button:
On a type 1 E.V.B., the slats tilt to the closed position then
move to the newly set "my" position.
On a type 3 E.V.B., the slats move back to the horizontal
position then move to the newly set "my" position.
To Next Page
Loading...
Need help?
General
