SOMFY J4 RTS User Manual

63
© 2011 Somfy SAS. All rights reserved. 06/2011
EN
2. SAFETY
2.1. Safety and responsibility
- The motor, the torque and the operating time must be adjusted according to the complete installation.
- Only Somfy original accessories should be used (adapters, brackets, connectors, power cable, etc.).
- Fitting, testing, commissioning and repair of the installation must only be carried out by qualied
personnel.
- Correct operation of the installation is only guaranteed if the installation and assembly have been
carried out according to best practices, if the electrical supply is adequate and if maintenance is
carried out.
- The installer must also comply with the current standards and legislation in the country in which
the product is being installed, and inform his customers of the usage and maintenance conditions
relevant to the product.
- The moving parts of the motors must be protected if operating at less than 2.50 m from the ground
or another surface.
- The installation must not be used if it shows any signs of damage (for example wear, damaged
cables and springs or ill adjusted end limits).
- The installation must be protected from all unauthorised use. Take preventive measures to avoid
any spurious operation.
- Children must be supervised to ensure they do not play with the equipment. Keep remote controls
out of the reach of children.
- This equipment is not intended for use by persons (including children) with impaired physical or
mental capacities or those without the required knowledge or experience unless supervised by a
person responsible for their safety.
- Disconnect all the connection cables from the power supply before operating on the installation.
- Do not use the installation if operations (window cleaning for example) are being carried out nearby.
- Observe the assembly and use guidelines, in particular the safety instructions from the manufac-
turer of the device to be used.
Subject to technical modications.
2.2. Specic safety advice
In addition to the safety instructions described in this guide, be sure to also observe the
instructions set out in the attached document "Safety instructions to follow and keep".
1) Switch off the mains supply for the external venetian
blind before performing any service operation in the
vicinity.
To avoid damaging the product:
2) Never immerse it in liquid!
3) Avoid impacts!
4) Do not drop it!
5) Never drill holes in it!
6) Avoid moving the blind if ice has formed on it.
1
3
5 6
2
4
OFF

SOMFY J4 RTS Specifications

General

Brand	SOMFY
Model	J4 RTS
Category	Controller
Language	English