Somfy Rollup 28 Motor Control Programming
Pairing-Deleting A Multi Channel Control
Step 1 / 4
Pair or delete a control channel to a blind using the
motor program/reset button - applicable to:
Somfy Rollup 28 RTS
Somfy Rollup 28 RTS Li-ion (integral battery)
This procedure enables a control channel to be paired
to a blind without the need to disconnect power to
other blinds in range.
Step 2 / 4
Press and hold the program/reset button on the
motor head until the blind jogs Up/Down - then
release (about 2-3 seconds).
The motor is now in programming mode and will now
accept a control channel to either pair or delete.
If the control channel selected is not currently paired
to the motor, then it will be added.
If the control channel selected is currently paired to
the motor, then it will be deleted.
Warning
Only hold the motor program/reset
button until the blind jogs a single time
- then release. Holding the button down
too long may result in a motor reset.
Version 41
27
To Next Page
Loading...
