SOMFY Roller Blind - Delete All Recorded Controls and Pair a New Control-Channel

Somfy Rollup 28 Motor Control Programming
Delete All Recorded Controls And Pair A
New Control-Channel
Step 1 / 3
This procedure will allow you to delete all previously
stored controls/channels in the memory of the motor
and overwrite with a new single channel control or
multi channel control channel.
This process is carried out using the motor program/
reset button - applicable to:
Somfy Rollup 28 RTS
Somfy Rollup 28 RTS Li-ion (integral battery)
Step 2 / 3
Press and hold the program/reset button on the
motor head until the blind jogs Up/Down twice - then
release (about 5-6 seconds).
All previously recorded controls/channels have now
been deleted and the motor is in a programming
mode to accept a new control or channel.
ATTENTION - Release the button as soon as the blind
has jogged twice. If you keep hold of the button and
allow the blind to jog three times you will reset the
motor.
Version 41
29